Error

2016年5月30日 — It is either a loose connection on the wires where they attach to the thermistor or the thermistor is cracked. Usually the thermistor itself ...

2017年1月14日 — The larger wires and screw terminals at the back are the heater cartridges and as stated, they would not trigger a mintemp error. They could ...

2019年9月2日 — since this morning I get the following error code, when I start up the machine (see photo). Board Error: Error:00: Extruder switched off.

2012年12月6日 — I receive this message intermittently when printing. I thought it might be a loose connection to the Thermistor, ...

2018年4月14日 — O and here is a picture where thermometer is working fine while there is error on screen. ... 17:54:49.757 : : Extruder switched off. MINTEMP ...

2014年11月30日 — If a temperature reading is zero, the corresponding thermistor circuit for measuring that temperature is open somewhere. Each thermistor (one ...

the printer is turned OFF and unplugged from electricity; the hotend and the heatbed are cooled down to ambient temperature. Since we will handle tools and work ...

If it's been working fine for a long time, it seems more likely that it's caused by the thermistor briefly disconnecting and the temperature dropping below ...

2016年7月21日 — MINTEMP is caused by bad or broken connection for the thermistor, which means it's getting disconnected. From your description, it's ...

2017年1月6日 — Firmware continues to try to heat hot end to target temp and never shuts off. Thermal Runaway.